Peak Werks

PEAK Front Carbon Ceramic Upgrade Pads for Audi S3 (8V)

$720.00
Or 4 payments of $180.00, interest free AfterpayPayPal
Or pay over time Zip

SKU: PW-CCUP-336-F

  • S1 Street compound made for carbon ceramic rotors
  • Fits your original calipers
  • Ships 10 to 15 days after fitment is checked
Book fitting with a recommended fitter
Shipping estimate

The pads

S1 Street, made for carbon ceramic.

S1 Street replacement pads for cars fitted with a PEAK carbon ceramic upgrade. Each listing is one axle set, made to your car's factory pad shape to fit your original calipers and your PEAK carbon ceramic rotors.

S1 Street is a ceramic compound made for carbon ceramic discs. It holds a steady 0.38 to 0.43 friction coefficient from 0 to 700°C, runs quiet and keeps your wheels clean with very low dust, and resists fade when you drive hard.

These pads are for carbon ceramic rotors only. If your car still has its factory steel rotors, start with the PEAK carbon ceramic upgrade kit for your car, which comes with a full set of pads.

Every order is checked against your VIN before it ships, so you get the right pads for your car's exact brake package.

PEAK Werks carbon ceramic brake pads
Axle set
Brake pads on a carbon ceramic rotor
Fitted

Your order

Checked before it ships.

  • 01OrderAdd your VIN when you order, or send it after.
  • 02We check fitmentWe match your VIN to your car's exact brake package.
  • 03ShippedYour pads ship within 10 to 15 days of us confirming fitment.
  • 04FittedHave them fitted by a qualified workshop, then bed them in.

Questions

Good to know.

Will they fit my original calipers?

Yes. The pads are made to your car's factory pad shape, so they fit your original calipers and work with your carbon ceramic rotors. We check your VIN before they ship.

Can I use them with steel rotors?

No. S1 Street is made for carbon ceramic rotors only. If your car still has steel brakes, start with a PEAK carbon ceramic upgrade kit. It comes with the rotors and a full set of pads.

Is it one axle?

Each listing is one axle set: pads for the left and right caliper. Front and rear are listed separately. Add both to your cart if you're doing the whole car.

Do I need to bed them in?

Yes. New pads need bedding in before any hard driving. It takes about 15 minutes on a quiet road, and the steps are on our questions and care page.

Are wear sensors included?

No. Reuse your existing wear sensors if they are in good condition. If a sensor has been triggered, fit a new one with the pads.

How do I find my VIN?

Your VIN is on your registration papers, at the base of the windscreen on the driver's side, and inside the driver's door frame. Our fitment guide shows where to look.

Rotors worn too?

Our rotor kits come with a pair of carbon ceramic rotors and a full set of pads for one axle, matched to your car.